tag:blogger.com,1999:blog-2252973662798952348.post6714947633931252675..comments2023-09-23T11:53:00.261+03:00Comments on Jubito: Simple interface example with arduinoJ@mBeLhttp://www.blogger.com/profile/08070875800918729353noreply@blogger.comBlogger5125tag:blogger.com,1999:blog-2252973662798952348.post-1116337509110520892017-05-17T06:58:33.179+03:002017-05-17T06:58:33.179+03:00Check the link find out more on arduino tutorials ...Check the link find out more on arduino tutorials before first screenshot. This post is very general just to describe the concept.J@mBeLhttps://www.blogger.com/profile/08070875800918729353noreply@blogger.comtag:blogger.com,1999:blog-2252973662798952348.post-64862619778932736642017-05-16T23:13:03.513+03:002017-05-16T23:13:03.513+03:00Where is some arduino code for this?
Where is some arduino code for this?<br />Anonymoushttps://www.blogger.com/profile/05719832640464398064noreply@blogger.comtag:blogger.com,1999:blog-2252973662798952348.post-88464803243506330332016-12-01T10:33:09.005+02:002016-12-01T10:33:09.005+02:00Operation completed is also returned when com port...Operation completed is also returned when com port is not properly communicate with Jubito.J@mBeLhttps://www.blogger.com/profile/08070875800918729353noreply@blogger.comtag:blogger.com,1999:blog-2252973662798952348.post-84869530166061288752016-11-30T16:34:40.987+02:002016-11-30T16:34:40.987+02:00Hi Sakis,
Operation Completed is the default actio...Hi Sakis,<br />Operation Completed is the default action when no value has been returned. Make sure your arduino reply at your command httempc on its serial monitor. You can send me at jambel@jubito.org your sketch and Jubito's AppConfig.xml to review and send it back to you.J@mBeLhttps://www.blogger.com/profile/08070875800918729353noreply@blogger.comtag:blogger.com,1999:blog-2252973662798952348.post-41235578557731588512016-11-30T15:31:31.034+02:002016-11-30T15:31:31.034+02:00I followed the steps percisely as you said but aft...I followed the steps percisely as you said but after the first time i run the command: judo serial send httempc i get: Operation completed rather than the degrees.<br />After that i have to unplug my arduion and plug it again.<br />Any kind of help would be very much appreciated.Anonymoushttps://www.blogger.com/profile/05509802745690456988noreply@blogger.com